Teldat bintec W1002n Manual de usuario descargar pdf (Pagina 231)

100

101

11.4.5 Rogue APs

Fig. 96: Wireless LAN Controller->Monitoring->Rogue APs

APs which are using an SSID from their own network but are not managed by Wireless

LAN Controller are displayed in the Wireless LAN Controller->Monitoring->Rogue APs

menu. Rogue APs which have been found for the first time are displayed with a red back-

ground.

For each rogue AP you will see an entry with the following parameter set: SSID, MAC Ad-

dress, Signal dBm, Channel, Last seen, Detected via AP,Accepted.

Note

Check the rogue APs shown carefully, as an attacker could attempt to spy on data in

your network using a rogue AP.

You can class a rogue AP as trustworthy by enabling the Accepted checkbox. If an alarm

has been configured, this is then removed and no longer sent. The red background disap-

pears.

Click under New Neighborscan on Start, to rescan adjacent AP's. You will receive a warn-

ing that the wireless modules of the access points must also be disabled for a certain peri-

od of time. When you start the process with OK, a progress bar is displayed. The located

AP display is updated every ten seconds.

Teldat GmbH

11 Wireless LAN Controller

bintec WLAN and Industrial WLAN 217

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 553 554

Comentarios a estos manuales

Sin comentarios

Teldat bintec W1002n Manual de usuario Pagina 231

Comentarios a estos manuales