
bintec W150n
10.12.2013
Subject to technical alterations
Page 3 / 4
Teldat GmbH - Suedwestpark 94 - 90449 Nuremberg - Germany
Phone: +49 - 911 9673-0 - Telefax: +49 - 911 688 07 25
Wireless LAN
Transmit power max. 17.5dB @ 802.11b; max. 15 dBm @ 802.11g; max. 14 dBm @ 802.11n MCS7 HT40; + 2 dB
Antennengewinn
Receiver Sensitivity -85dBm @ 802.11b / 11 Mbit/s; -68dBm @ 802.11g / 54 Mbit/s; -68dBm @ 802.11n MCS7 HT20/40;
-82dBm @ 802.11n MCS0 HT20/40
WMM (Wi-Fi Multimedia) Supported
Antenna 2dBi omni-directional antenna, detachable; at the unit is a RSMA connector (male)
Security
Standards WEP, WPA, WPA2; 802.1x only for AP Mode
Wireless Protected Setup (WPS) Pin Method, Push-Button Method
Network Name (SSID) Up to four SSID defineable
Network Name (SSID) Visibilty On/off
Intercell Repeating On/off (allows or disallows the communication between associated Wifi client)
Access Control List (ACL) MAC Addresses defineable as White List or as Black List
WLAN on/off Supported
Maintenance
Configuration Web-GUI (http) in English language
Configuration Wizard Yes
Dime Manager Support No
WLAN Controller Support No
Firmware Update Yes
Configurations Management Save/Restore as file
Statistics For each interface separate RX/TX counter
Hardware
LAN Interface 10/100Base-T Ethernet, Full duplex with Auto MDI/MDIX support; fixed IP Address or DHCP Client
(only in AP mode)
Power supply 5V/1A DC via wall adapter
Power supply unit Wide range switched powered wall adapter 100-240V AC 50/60Hz
Power consumption 3 Watt
Reset Button Set the device to back factory settings
LEDs Operation, LAN Link, Wifi active
Dimensions 102 x 71 x 20 mm (length x wide x height)
Wall mounting No
Comentarios a estos manuales